Re: Printed a Shaft Seal Installer Tool on my 3D printer
Posted: Tue Oct 31, 2017 4:00 pm
CC Creator,
Wish I had my snow cycle pictures to post. Centrifugal clutch with variable diameter sheaves to a jack shift and chain drive to rear axle with monster lightened sprocket.
Wide Terra tires to plow through the CO snow high country during hunting season.
All aluminum fabed frame (argon gas welded) and fenders with gas tank incorporated into near horizontal 4" frame tube with gas feed from either end for uphill or downhill.
Top speed about 20 mph.
Those were the days my friend, those were the days!
I loved night school machining classes at Croizer Tech in Dallas so I rebuilt a old broken WW11 engine lathe for my shop.
hotrodac
Wish I had my snow cycle pictures to post. Centrifugal clutch with variable diameter sheaves to a jack shift and chain drive to rear axle with monster lightened sprocket.
Wide Terra tires to plow through the CO snow high country during hunting season.
All aluminum fabed frame (argon gas welded) and fenders with gas tank incorporated into near horizontal 4" frame tube with gas feed from either end for uphill or downhill.
Top speed about 20 mph.
Those were the days my friend, those were the days!
I loved night school machining classes at Croizer Tech in Dallas so I rebuilt a old broken WW11 engine lathe for my shop.
hotrodac
